Thursday 30 September 2021

Plenty of Cavalry...

I don't really do rebasing; it's enough faff the first time round... These days new sets of rules are less obsessive about the exact frontage of a wargame figure unit or the number of figure per square inch. A rare exception is these Corvus Greek cavalry. I decided to reduce the figures in the Thessalian unit down to a Piquet standard 8 figures (for cavalry.) Part of the decision was that I knew I had spare   figures that would go with the discarded four to make up a whole new unit (and half already painted!)

 


I had 2 of the Corvus cavalry and 2 Newline figures that fitted in quite nicely on Corvus horses. The Greeks were a bit slower to adopt shields and for the most part preferred throwing javelins from a distance to charging in with lances. They were usually a small minority in a Greek army, so probably a good survival tactic! 

 The General on the fancy base highlights one of the problems that some older figure ranges could suffer from. His horse was one of a number that snapped off at the ankles due to the metal being a bit soft. The tail also became a casualty where there was a slight moulding fault at the narrowest part. I must have been in a frugal phase, as I took the time to pin the horse through a thick resin base I had picked up somewhere. I also rebuilt the horse's tail and the saddlecloth lion's tail using wire and milliput. 

 


 I was very happy  with the result, at the limits of my modelling ability at the time. He stands out nicely on his raised base too.

 


 Greek heavy cavlary are quite useful as mercenaries in a Successor army. Maybe only in a second line role but fairly competant and reliable.

3 comments:

  1. A good recovery!

    I have had a few commanders in my day, esp some on rearing horses, who ended up being supported by a bush which grew up around a length of wire.

    ReplyDelete
    Replies
    1. You can hide a lot with a strategic piece of lichen or sponge!

      Delete

 Waterloo  - But Not As we Know It!